PREPARATION OF THE BASE:
The preparation of the base is carried out in accordance with State Building Norms of Ukraine V.2.6-22-2001 and Building regulations 3.04.01-87. The substrate must be dry, not frozen, strong, capable of bearing the load, free of dust, dirt, oils, grease, and old paint residues. Fragile, old coatings and oil contamination are carefully removed. Inequalities, chips, shells, cracks shall be restored using TM SCANMIX repair mixtures. Cement plastered surfaces with a thickness of more than 10 mm must be cured for at least 14 days, plastered surfaces for at least 3 days, and surfaces of thermal insulation systems – 7 days. All surfaces need to be treated with an adhesive primer TM SCANMIX. When using tinted plaster, the primer paint should be the same color. The surfaces strongly absorb moisture, pretreat with a primer deep penetration TM SCANMIX. Areas affected by micro-organisms are mechanically cleaned and treated with antiseptic primers.
APPLICATION:
Immediately before using decorative plaster, all contents of the package should be very carefully mixed until a uniform consistency is obtained, and in order to avoid different shades of colour we propose to mix all volume of plaster. If necessary, add a small amount of water (only for correction, maximum 1.5%).If sprayed, the maximum water additive is up to 100 ml per 25 kg of plaster. The quantity of water added for each package must be the same. Adding water can change the working properties of the plaster and its colour.
If carried out manually, apply the plaster with the aid of a stainless steel ironing, distribute until the layer is in the grain. Once the mass is applied, it must be given the right structure.
Apply at base and ambient temperatures from + 5 ° C to + 25 ° C.
Do not apply to the heated surface. Direct sunlight, high wind and humidity above 65% should be avoided during operation as well as during drying. Protect the plaster to full drying by means of a film or a dense protective mesh. The temperature of the substrate and environment at the time of application and for the next 48 hours shall not be less than + 5 ° C.
The drying time at temperature + 20 ° C and the relative humidity of 65% is 24 hours. The plaster fully dries it can be subjected to a load after 2-3 days.
COLOUR: White.
TONNAGE: Toned according to the COLOR MIX system.
CONSUMPTION: The grain size of 2,0 mm 2,4 kg/m² is the precise flow rate determined by the test application at the facility.
STORAGE: In tightly closed packagings, at a temperature of 5°C and not exceeding 30°C.
BEST BEFORE: 24 months from date of manufacture.
CAPACITY: 25 kg.
The information contained in the description is intended to ensure that plaster work is properly performed. The manufacturer shall not be liable for any combination with other producers or damage caused by the improper or improper use of the product.
