The cellular heat-retaining glue is used for erecting external and internal walls with ...

Cement mixture for masonry walls, used for the construction of facades of silicate and ...
The preparation of the framework shall be in accordance with State Building Norms of Ukraine V.2.6-22-2001. The base shall be clean, strong, dry. The roughness and imperfect parts of the base must be cleaned and then leveled with a dissolved mixture 24 hours before the start of work. To improve the adhesion, the surface needs to be treated with SCANMIX primer. The gluing work shall not commence until two hours after the primer has been applied.
Fill the dry mixture with clean water (water temperature from +15°C to +20°C) at a rate of 0.16-0.20 l/kg adhesive and mix until a homogeneous mass without lumps is obtained by means of a low-rotating drill or mixer. Then the dissolved mixture will last 3-5 minutes, then mix again. The solution is suitable for use for 4 hours. The prepared mixture is uniformly applied to the contact surface with the aid of a cologne or a steel spatula and evenly distributed by a toothed spatula. The blocks are applied, slightly pressed. The glue is performed within 20 minutes from the time the solution layer is applied to the base. Once the blocks have been laid, they can be adjusted for 10 minutes. The solidification time of the mixture depends on the type of base, temperature and humidity of the air and is about 24 hours.
The work must be performed at a base temperature ranging from +5°C to +30°C. All the above recommendations are most effective at a temperature of +20°C and relative humidity of 60%. Under other conditions, technological parameters may change.
The manufacturer shall not be liable for improper use of the material or its use for purposes and conditions not provided for in the instruction.
The solution and water should not be poured out after working in sewer pipes. It is desirable to work in rubber gloves. Contact with the skin or eyes shall be avoided. If the solution enters the skin or eyes, it is necessary to wash it thoroughly with water, since the mixture contains cement which, when mixed with water, forms an alkaline medium.
In dry space and on pallets, in factory packaging: 12 months from the date of issue indicated on the package.
The dry mixture is packed in paper bags of 25 kg.
COMPOSITION: Mixture of cement with mineral fillers and special additives | |
Color | gray |
Maximal grain | 0,3 mm |
Amount of water to mix solution | 0,16-0,2 l/kg mixture |
Layer thickness | from 2 mm |
Life of dissolved mixture | up to 4 hours |
Compressive strength | not less than 10 megapascals |
Strength of adhesion to base (dry air) | not less than 0,5 megapascals |
Frost resistance | 50-70 cycles |
Core temperature | from +5°С to +30°С |
Operating temperature
Thermal conductivity |
from -50°С to +90°С not greater than 0,17 Thermal conductivity |
Consumption* | 2 to 3 kg/m2/mm |
* Depends on spatula teeth size and base roughness (1 bag of mixture – average of 55 foam concrete blocks of 200x300x600 mm)