Scanmix EASY 102

arrow_hist Glue arrow_hist Tile adhesive
Scanmix EASY 102

Tile adhesive, economical, used for gluing ceramic, stone and other tiles with a water ...

Read More
Scanmix GRES 112

Tile adhesive, standard, used for gluing (outside or inside) ceramic tiles,glass mosaics, ...

Read More
Scanmix STANDART Winter 113

Glue for tiles on internal and external surfaces of buildings. Allows to perform works at ...

Read More
Scanmix PLASTIC 117

Tile adhesive, elastic, intended for tiling with ceramic tiles made of natural and ...

Read More
Scanmix MULTISUPER White 115

Glue for tiles, white, high elastic, is intended for coating of surfaces with increased ...

Read More
Scanmix MULTISUPER Grey 119

Glue for tile, grey, high elastic, is intended for coating surfaces with increased ...

Read More


  • Layer thickness 2-10 mm
  • User-friendly
  • Plastic
  • Frost resistant
  • Waterproof
  • Environmentally friendly


The base shall be dry, strong, dust-free, dirt-free, lime-free, grease stains or paint. The loose, defective layer shall be removed. It is recommended that recesses and irregularities larger than 5 mm be levelled with the same solution 24 hours before the start of work. All bases are treated 1-2 times with SCANMIX primer. Dry bases with good hygroscopy must be pre-wetted.


Mix dry mixture with clean water up to uniform mass, without lumps. After 5 minutes the finished solution should be mixed again. Apply a thin layer to the surface with a spatula. Then level the solution with a serrated spatula. The trowel teeth must be square and match the size of the tile (15×15 cm – 6 mm notches, 30×30 cm – 8 mm notches). Do not wet the tiles beforehand. It is not recommended to lay the tiles on the “joint”. The use of spacers is optional.Due to the characteristics of the solution, the laid tile is fixed on the surface and within 5 minutes it is possible to adjust its position. The time for laying tiles on the applied mortar is up to 30 minutes. With a decrease in temperature, the setting time of the glue increases.

The manufacturer shall not be liable for improper use of the material or its use for purposes and conditions not provided for in the instruction.


The solution and water should not be poured out after working in sewer pipes. It is desirable to work in rubber gloves. Contact with the skin or eyes shall be avoided. If the solution enters the skin or eyes, it is necessary to wash it thoroughly with water, since the mixture contains cement which, when mixed with water, forms an alkaline medium.


In dry space and on pallets, in factory packaging: 12 months from the date of issue indicated on the package.


The dry mixture is packed in paper bags of 25 kg.


COMPOSITION: Mixture of cement with mineral fillers and special additives
Color gray
Maximal grain 0,3 mm
Amount of water to mix solution 0,16-0,2 l/kg mixture
Final solution time up to 4 hours
Air temperature and bases when used from +5°С to +30°С
Sliding tiles missing
Strength of adhesion to base more than 0,5 megapascal
Layer thickness not more than 10 mm
Joint after 48 hours
Consumption (depending on the thickness of the layer applied)  2 to 4,5 kg/m2/mm