Decorative acrylic plaster with the structure in the form of «Bark beetle». The plaster is vaporizable, durable, with low atmospheric absorption and resistant to the influence of micro-organisms.It is intended for a decorative finishing layer device in TM SCANMIX thermal insulation systems. It is used to create durable and worn-out coatings on and inside facades. Recommended for restoration of monuments of architecture.

PREPARATION OF THE BASE:
The preparation of the base is carried out according toState Building Norms of Ukraine V.2.6-22-2001 and Building regulations 3.04.01-87 and shall be dry, durable, not frozen, capable of carrying a load, free of dust, dirt, oils, grease and old paint residues. Fragile, old coatings and oil contamination are carefully removed. Roughness, chips, cracks shall be restored using TM SCANMIX repair mixtures. Cement coated surfaces with a thickness of more than 10 mm shall be conditioned for a minimum of 14 days, spackled surfaces for a minimum of 3 days, and the surfaces of the insulation systems for 7 days. All surfaces need to be treated with an adhesive primer TM SCANMIX. When using tinted plaster, the primer must be tinted with the same color. Surfaces that strongly absorb moisture pre-treat deep penetration TM SCANMIX with primer. Areas affected by micro-organisms are mechanically cleaned and treated with antiseptic primers.
APPLICATION:
Immediately before using decorative plaster, all contents of the package should be very carefully mixed until a uniform consistency is obtained. And in order to avoid different shades of color, we suggest to mix all volume of plaster. If necessary, add a small amount of water (only for correction, maximum 1.5%). If sprayed, the maximum water addition is up to 100 ml per 25 kg of plaster. The quantity of water added for each package must be the same. Adding water can change the working properties of the plaster and its colour.
In the case of manual application, apply the plaster with a stainless steel trowel and spread until a layer is achieved into the grain. After applying the mass it is necessary to give it the necessary structure with the aid of a glassmaker made of plastic: «Bark beetle» – direct movements. Apply at base and ambient temperatures from + 5 ° C to + 25 ° C. Do not apply to the heated surface. Direct sunlight, high wind and humidity above 65% should be avoided during operation as well as during drying. Protect the plaster until it is completely dried with a film or a dense protective mesh. The temperature of the base and ambient environment during application and for the following 48 hours shall not be less than + 5° C.
DRYING TIME: At temperatures + 20 ° C and the relative humidity of 65% is 24 hours. The plaster is completely dry and can be loaded after 2-3 days.
COLOUR: White.
TONNAGE: Toned according to the COLOR MIX system.
CONSUMPTION: Grain size 2.0 mm – 2.5 kg /m²; the exact flow is determined by the test application at the facility.
STORAGE: In tightly closed packagings at temperatures + 5 ° C and not above + 30 ° C.
BEST BEFORE: 24 months from date of manufacture.
CAPACITY: 25 kg.
The information contained in the description is intended to ensure that plaster work is properly performed. The manufacturer shall not be liable for any combination with the products of other manufacturers and for any damage caused by the improper or incorrect use of the product.