Scanmix PLASTERSIL K 20

arrow_hist Plasters arrow_hist Facade silicone plasters arrow_hist Scanmix PLASTERSIL K 20
Scanmix PLASTERSIL K 20

Silicone plaster for decorative wall decoration outside as well as inside rooms with a “bark beetle” structure. It forms a water-repellent, elastic and durable coating. It is used for decoration of cement plaster, concrete, brick, surfaces of systems of thermal insulation of facades. It is intended for places with aggressive influence of environment and on facades, insulated with mineral wool.No solvents. High vapour permeability.

Material consumption calculator

Enter the surface area, m²

You will need approximately 0kg

PREPARATION OF THE BASE:

The preparation of the base is carried out according to State Building Norms of Ukraine V.2.6-22-2001 and Building regulations 3.04.01-87. The substrate must be dry, not frozen, strong, capable of bearing the load, free from dust, dirt, oils, old paint residues. Fragile, old coatings and oil contamination are carefully removed. Cement plastered surfaces with a thickness of more than 10 mm must be cured for at least 14 days, putty surfaces at least 3 days, and surfaces of insulation systems within 7 days. All surfaces need to be treated with an adhesive primer TM SCANMIX. When using tinted plaster, the primer must be tinted with the same color. The surfaces strongly absorb moisture, pretreat with a primer deep penetration TM SCANMIX. Areas affected by micro-organisms are mechanically cleaned and treated with antiseptic primers.

APPLICATION:

Immediately before using decorative plaster, all contents of the package should be very carefully mixed until a uniform consistency is obtained. And to avoid different shades of color we suggest to mix all volume of plaster. If necessary, add a small amount of water (only for correction, maximum 1.5%). If sprayed, the maximum water additive is up to 100 ml per 25 kg of plaster. The quantity of water added for each package must be the same. Adding water can change the working properties of the plaster and its colour.

If carried out manually, apply the plaster with the aid of a stainless steel ironing, distribute until the layer is in the grain. After applying the mass it is necessary to give it the necessary structure.

Apply at base and ambient temperatures between +5°C and + 25° C.

Do not apply to the heated surface. Direct sunlight, high wind and humidity above 65% should be avoided during operation as well as during drying. Protect the plaster until it is completely dried with a film or a dense protective mesh. The temperature of the base and the environment at the time of application and for the following 48 hours shall not be less than +5° C.

COLOUR: White.

DRYING TIME: At temperature +20 °C and the relative humidity of 65% is 24 hours/ The plaster is completly dry and can be subjected to load after 2-3 days.

TONNAGEe: Toned according to the COLOR MIX system.

CONSUMPTION: Grain size 2.0 mm – 2.8 kg/m², the exact flow is determined by the test application at the facility.

STORAGE: In tightly closed packagings at a temperature of +5°C and not exceeding 30°C.

BEST BEFORE: 24 months from date of manufacture.

CAPACITY: 25 kg.

The information contained in the description is intended to ensure that plaster work is properly performed. The manufacturer shall not be liable for any combination with other producers or damage caused by the improper or improper use of the product.