Glue for tiles, white, high elastic, is intended for coating of surfaces with increased density, with water absorption less than 1%, including deformations, all types of tiles made of natural stone, glass, dense concrete, mosaics, marble, etc. materials inside and outside the buildings. It is effective at lining surfaces without removing old tiles, i.e. «tiles on tiles»; for lining of bases exposed to constant atmospheric influences (terraces, balconies, operating roofs, etc.), and for the coating of heated floors. It is especially recommended for swimming pools, refrigeration chambers, as well as oven and fireplace lining. It is adhesive to almost any base.
Material consumption calculator
PROPERTIES:
Fibre-reinforced mixture
Elevated adhesion
Resistant to temperature and vibration
Nonshrinking
Ideal for old ceramic surfaces
Rapid pace of work
User-friendly
Highly plastic
Frost resistant
Waterproof
Environmentally friendly
PREPARATION OF THE BASE:
The base shall be dry, strong, dust-free, dirt-free, lime-free, grease stains or paint. The loose, defective layer shall be removed. All bases are processed 1-2 times with primer SCANMIX. Before laying the tiles on the old ceramic surface, the latter must be degreased with caustic soda (1 kg per 10 litres of water) and washed with clean water.
PERFORMANCE OF WORK:
The tile is not wetted. The adhesive solution is mixed manually or mechanically with clean water until a uniform consistency is obtained. After 5 minutes, the finished solution should be stirred again. The solution is applied by a thin layer to the prepared surface with the aid of a suitable serrated spatula (the size of the teeth can vary between 6 and 10 mm). They apply this much solution so they can glue the tiles in 30 minutes. Due to the special qualities of the solution, the laid tile is fixed on the surface and within 15 minutes it is possible to adjust its position. After 48 hours, the surface can be used and sutures can be fugged.
When laying the tiles on the heated surface, it is necessary to warm the floor by turning on the heating, and 1-3 days before work is done to turn it off. The heating can be used 2 days after the fumigation of the seams.
Under adverse weather conditions (high temperature, dry wind, direct sunlight), the time taken to apply a surface solution can be significantly reduced.
The tool is washed with clean water immediately after use; do the same with contaminated tiles before / after installation.
The manufacturer shall not be liable for improper use of the material or its use for purposes and conditions not provided for in the instruction.
SAFETY PRACTICES:
The solution and water should not be poured out after working in sewer pipes. It is desirable to work in rubber gloves. Contact with the skin or eyes shall be avoided. If the solution enters the skin or eyes, it is necessary to wash it thoroughly with water, since the mixture contains cement which, when mixed with water, forms an alkaline medium.
SHELF LIFE:
In dry space and on pallets, in factory packaging: 12 months from the date of issue indicated on the package.
PACKAGE:
The dry mixture is packed in paper bags of 5 and 25 kg.
TECHNICAL CHARACTERISTICS:
COMPOSITION: Cement sand modified with polymer additives
Color
white, gray
Placeholder size
not more than 0,3 mm
Amount of water to mix solution
0,16-0,18 l/kg mixture
Final solution time
240 min
Open time
25-30 min
Adjustment time
15-25 min
Base temperature of mixture application
from +5°С to +35°С
Operating temperature
from -50°С to +120°С
Strength of adhesion to concrete base
1,7 megapascal
Flexural strength
not less than 2,5 megapascal
Layer thickness
not more than 15 mm
Technological transfer time
48 hours
Joining seams
24 hours
Frost resistance
at least 50 cycles
Consumption (depending on the thickness of the layer applied)
