arrow_hist Plasters arrow_hist Facade silicone plasters arrow_hist Scanmix PLASTERSIL K 15

Silicone plaster for decorative finishing of walls outside as well as inside of premises with structure in the form of «lamb».It forms a water-repellent, elastic and durable coating. It is used for decoration of cement plaster, concrete, brick, surfaces of systems of thermal insulation of facades.It is intended for places with aggressive influence of the environment and on facades of heated mineral wool. It does not contain solvents. High Permeability.

Material consumption calculator

Enter the surface area, m²

You will need approximately 0 kg


The preparation of the base is carried out in accordance with State Building Norms of Ukraine V.2.6-22-2001 and Building codes and regulations 3.04.01-87. The base shall be dry, not frozen, strong, capable of carrying a load free of dust, dirt, oils, fats and old paint. Fragile, old coatings and oil contamination are carefully removed.Roughness, shell chips, cracks to be restored using TM SCANMIX repair mixtures. Cement plastered surfaces more than 10 mm thick must be sustained for a minimum of 14 days, putty surfaces- at least 3 days, and the surfaces of the insulation systems for 7 days.All surfaces need to be treated with an adhesive primer TM SCANMIX. When using tinted plaster, the primer paint should be the same color. Surfaces that strongly absorb moisture pre-treat deep penetration TM SCANMIX with primer.Areas affected by micro-organisms are mechanically cleaned and treated with antiseptic primers.


Immediately before using decorative plaster, all contents of the package should be very carefully mixed until a uniform consistency is obtained. And to avoid different shades of color we suggest to mix all volume of plaster.If necessary, add a small amount of water (only for correction, maximum 1.5%). If sprayed, the maximum water additive is up to 100 ml per 25kg of plaster. The quantity of water added for each package must be the same.Adding water can change the working properties of the plaster and its colour.

If carried out manually, apply the plaster with the aid of a stainless steel ironing, distribute until the layer is in the grain. After applying the mass it is necessary to give it the necessary structure ( Lamb» – circular movements) using a plaster trowel.

Apply at base and ambient temperatures of +5°C to + 25°C.

Do not apply to the heated surface. Direct sunlight, high wind and humidity above 65% should be avoided during operation as well as during drying.Protect the plaster until it is completely dried with a film or a dense protective mesh. The temperature of the base and the environment during application and for the following 48 hours shall not be less than +5°C.

DRYING TIME: At temperatures + 20°C and the relative humidity of 65% is 24 hours. The plaster is completely dry and can be loaded after 2-3 days.

COLOUR: White.

TONNAGE: Toned according to the COLOR MIX system.

CONSUMPTION: The grain size of 1,5 mm – 2,4 kg/m² the exact consumption is determined by a trial application on the object.

STORAGE: In tightly closed packagings at a temperature of +5°C and not exceeding 30°C.

BEST BEFORE: 24 months from date of manufacture.

CAPACITY: 25 kg.

The information contained in the description is intended to ensure the proper performance of the plaster work. The manufacturer shall not be liable for any combination with the products of other manufacturers and for damage caused by the improper or incorrect use of the product.