Scanmix PLASTIC 117

arrow_hist Glue arrow_hist Tile adhesive arrow_hist Scanmix PLASTIC 117
Scanmix PLASTIC 117

Tile adhesive, elastic, intended for tiling with ceramic tiles made of natural and artificial stone (with a water absorption of less than 2% and a size of 60 × 60 mm and more) bases (walls and floors), including those that are periodically subject to deformation, – inside and outside buildings. Effective when installing “warm floors” and stairs. Recommended for performing works by the “tile on tile” method (facing surfaces without removing old tiles).

Material consumption calculator

Enter the surface area, m²

You will need approximately 0kg

PROPERTIES:

  • Fibre-reinforced
  • Elevated adhesion
  • Stable on vertical surfaces
  • Fast-hardening
  • User-friendly
  • Highly plastic
  • Frost resistant
  • Waterproof
  • Environmentally friendly

PREPARATION OF THE BASE:

The base shall be dry, strong, dust-free, dirt-free, lime-free, grease stains or paint. The loose, defective layer shall be removed. All bases are processed 1-2 times with primer SCANMIX. Before laying tiles on an old ceramic surface, the latter must be degreased with caustic soda (1 kg per 10 liters of water) and rinsed with clean water. It is also advisable to strengthen the base by breaking the netting “netting” on top of the old tile.

PERFORMANCE OF WORK:

The tile is not wetted. The adhesive solution is mixed manually or mechanically with clean water until a uniform consistency is obtained. After 5 minutes, the finished solution should be stirred again. he solution is applied by a thin layer to the prepared surface with the aid of a suitable serrated spatula (the size of the teeth can vary between 6 and 12 mm). They apply this much solution so they can glue the tiles in 30 minutes. Due to the special qualities of the solution, the laid tiles are fixed on the surface and within 10 minutes it is possible to adjust its position. After 12 hours, you can use the surface and join the seams.

IMPORTANT INFORMATION:

Under adverse weather conditions (high temperature, dry wind, direct sunlight), the time taken to apply a surface solution can be significantly reduced. To prevent this, we recommend wetting the surface of the base or protecting the surface from direct sunlight. As the temperature decreases, the capture time increases.

The only thing to pour in the mixture is cool water. The instrument is washed with clean water immediately after use and contaminated tiles before/after laying.

The manufacturer shall not be liable for improper use of the material or its use for purposes and conditions not provided for in the instruction.

SAFETY PRACTICES:

The solution and water should not be poured out after working in sewer pipes. It is desirable to work in rubber gloves. Contact with the skin or eyes shall be avoided. If the solution enters the skin or eyes, it is necessary to wash it thoroughly with water, since the mixture contains cement which, when mixed with water, forms an alkaline medium.

SHELF LIFE:

In dry space and on pallets, in factory packaging: 12 months from the date of issue indicated on the package.

PACKAGE:

The dry mixture is packed in paper bags of 25 kg.

TECHNICAL CHARACTERISTICS:

COMPOSITION: Cement sand modified with polymer additives
Color gray
Placeholder size not more than 0,3 mm
Amount of water to mix solution 0,16-0,20 l/kg mixture
Final solution time
120 min
Open time 20-25 min
Adjustment time 15-20 min
Base temperature of mixture application from +5°С to +35°С
Operating temperature
from -50°С to +90°С
Strength of adhesion to concrete base 1,0 megapascal
Flexural strength not less than 2,5 megapascal
Lyer thickness not more than 15 mm
Technological transfer time 8 hours
Joining seams 12 hours
Frost resistance at least 50 cycles
Consumption (depending on the thickness of the layer applied) 2 to 8 kg/m2