Scanmix S White 521

arrow_hist Putties arrow_hist Scanmix S White 521
Scanmix S White 521

Facade finishing putty for creating perfectly smooth surfaces.The solution is intended for levelling the wall surface with a thin layer of 2-5 mm inside and outside the premises.The putty solution can be used as a decorative layer, as well as as a base for painting. You can wipe to get a perfectly smooth surface. The solution is plastic, well adhesive to solid bases, passes water vapour, at the same time does not allow moisture to pass inside, resistant to the effects of external medium (wind, precipitation, solar rays).

Material consumption calculator

Enter the surface area, m²

You will need approximately 0kg

PROPERTIES:

  • Thin-layer, clean-cut facade walls
  • Steam-permeable
  • Ability to create an invoice
  • Usability
  • Does not burn
  • Frost resistance
  • High water resistance
  • Environmentally friendly

PREPARATION OF THE BASE:

The solution can be applied on the surface of concrete, cement, brick, treated with SCANMIX TT solution, drywall and other building plates. The surface to be treated shall be level and strong, free from dust, dirt, grease, oils and other, and free from the laxative adhesion of substances. Imperfect layers need to be removed. All bases are treated 1-2 times with primer SCANMIX.

PERFORMANCE OF WORK:

The mixture is added to water and stirred mechanically until the desired thickness of the solution is obtained. After a 5-minute exposure, the finished solution should be mixed again. The solution retains its properties for approximately 4,5 hours. In the process of work, it is recommended to stir the solution from time to time to obtain a homogeneous mass. The mortar is applied to the base by hand with a metal float or a squeegee and leveled. After setting, the surface is rubbed with a damp felt float. The irregularities are polished with abrasive materials after complete drying. The SCANMIX S solution is coated with a layer of 2-3 mm in order to obtain the texture surface and the necessary texture is given with the aid of the spackle tools. The solution applied to the surface shall be protected from rapid drying and direct sunlight.

The manufacturer shall not be liable for improper use of the material or its use for purposes and conditions not provided for in the instruction.

SAFETY PRACTICES:

Do not pour mortar and water into sewer pipes after work. It is advisable to wear rubber gloves. Avoid contact of the solution with the skin or eyes. In case of contact with the solution, it is necessary to thoroughly rinse them with a large amount of water, since the mixture contains cement, which forms an alkaline solution with water.

SHELF LIFE:

In dry spaces and pallets, in original packaging: 12 months from the date of production indicated on the package.

PACKAGE:

Dry mixture packed in paper bags of 5 kg 25 kg.

TECHNICAL CHARACTERISTICS:

  • Composition: Mixture of white cement with mineral fillers modified with polymer additives.
  • Colour: White.
  • Maximum grain: not more than 0,1 mm.
  • Amount of water to mix solution: 0,25-0,35 l / kg mixture (6,25-8 l per 25 kg mixture).
  • Time of use: 240 min.
  • Temperature (air and base) when used: from + 5° C to 30 ° С.
  • Strength of adhesion to concrete base: 0,8 megapascals.
  • Maximum thickness of the layer: 5 mm.
  • Compression strength: 7 megapascals.
  • Vapour permeability: not less than 0,05 megapascals.
  • Consumption: (depending on the thickness of the layer applied) from 1 to 1,2 kg / m² / mm.