Pour the dry mixture in a container with clean water of room temperature in proportion : 0.18-0.20 l per 1 kg of mixture ( 4.0-5.0 l per sack of 25 kg). Thoroughly mix with mixer or low rotating drill with nozzle up to uniform consistency without lumps and clots. Then let the solution stand for 5 minutes and mix thoroughly again. The solution obtained must be used for 2 hours. Use clean tanks and tools for cooking. Apply the finished solution with a construction cell or ladle, and not later than 5-7 min. Leveling the metal rule on the beacons, then dismantle the beacons. Fill the areas filled with solution with the help of a master and level. After a 1,5-2 hour break, the surface is tilted, slightly wetted and covered with a plaster grater. In multi-layer application, the surface shall not be reclaimed. The surface under the tile shall not be reclaimed. Use pure water only. Do not mix with other materials. The plastered surface shall be wetted within 48 hours after completion of work. In order to carry out further work it is necessary to support a technological break of 10 days for every 10 mm layer of plaster. Comply with State Building Norms of Ukraine V.2.6 -22:2001.
Preparation and application by plaster unit:
To apply a universal plaster mixture SCANMIX CMP can be used any plaster station (e.g., MAI 4 you , PFT G4 or another similar station ). Apply the plaster mixture to the surface with a nozzle and no later than 5-7 minutes. Leveling the metal rule on the beacons, then dismantle the beacons. The areas filled with solution are filled with solution mixture and with the help of a master and level. After a 1.5-2 hour break, the surface is tilted, slightly wetted and covered with a plaster grater. Work to be performed at air and base temperature +5°C … 30°C and relative air humidity above 60%. You can’t use tools and iron dishes to work – they rust. Freshly laid mixtures must be protected against rain, overheating and direct sunlight. Under other conditions, the working parameters of the mixture may change. If a plaster is used in a non-standard environment or for other purposes, it is necessary to conduct the tests themselves or to consult with the manufacturer.
The manufacturer shall not be liable for the misuse of the material as well as its use for other purposes and under conditions not specified in the technical description.