- Layer thickness 5-20 mm
- Frost resistant
- High adhesion
PREPARATION OF THE BASE:
The base must be dry and strong, without damage. Paint, oil or wax stains and any substance that reduces adhesion, as well as degraded and weak areas, should be removed. The cleaned base should be dust-free. Areas with evidence of biological corrosion should be treated with antiseptic or removed by mechanical means. The new brick walls, made up of sill, should be free of dust in front of the plaster. Old brick walls should be cleaned with steel brushes or sandblasting apparatus, impregnated with Scanmix primer and dried for at least 2 hours. When using mixtures for laying, surfaces in contact with the solution should be prepared to increase adhesion, taking into account the above-mentioned recommendations. In preparing the basis, be guided by the requirements Building regulations 3.04.01-87 and State Building Norms of Ukraine V.2.6 -22-2001.
PERFORMANCE OF WORK:
Pour the dry mixture in a container with clean water of room temperature in proportion . 0.15-0.18 l per 1 kg of mixture (3,75-4,50 l per sack of 25 kg). Thoroughly mix with mixer or low rotating drill with nozzle up to uniform consistency without lumps and clots. After that, the solution will last five minutes and be thoroughly mixed again. The resultant solution must be used for 2 hours. Clean containers and tools must be used for preparation. The storage solution represents the finished mixture and does not require the addition of cement, sand or pigment. The solution mixture is applied to the prepared surface by a drawing followed by levelling and smoothing with graters. The mixture shall be uniformly applied to the surface by means of a wizard. Recommended thickness of the working seam from 6 mm.M The validation time of the mixture depends on the base, temperature and relative humidity of the air and is a minimum of 24 hours.
Work to be performed at air and base temperature +5°C … 30°C and relative air humidity above 60%. You can’t use tools and iron dishes to work – they rust. Freshly laid mixtures must be protected against rain, overheating and direct sunlight.
|Wall thickness (solid brick)
||Mixture flow at 10 mm seam thickness
The solution and water should not be poured out after working in sewer pipes. It is desirable to work in rubber gloves. Contact with the skin or eyes shall be avoided. If the solution enters the skin or eyes, it is necessary to wash it thoroughly with water, since the mixture contains cement which, when mixed with water, forms an alkaline medium.
In dry space and on pallets, in factory packaging: 12 months from the date of issue indicated on the package.
The dry mixture is packed in paper bags of 25 kg.
|COMPOSITION: Mixture of white cement with mineral fillers and special additives
||0,15-0,18 l/kg mixture
||up to 120 minutes
|Air temperature and bases when used
||from +5°С to +30°С
||at least 10 megapascals
|Ready for use (depending on layer thickness)
||after 48 hours
|Consumption (depending on the thickness of the layer applied)
||about 3,5 kg/m2 by 10 mm thickness
|Frost resistance, cycles, not less
||from -30°С to +70°С